V8 Baby Q2 0.4 Ω Coils by Smok – 5 pack

$25.00

1 in stock (can be backordered)

SKU: LUXSMOKV8BABYQ20.4COIL Categories: ,

**These replacement sub ohm coils are intended for use with the Smok TFV8 Baby/ Big Baby and Baby Prince tanks.

You’d be hard pressed to find a vape store that does not stock Smok vaporisers and parts. One of the giants of the vape world with a myriad of vapes/tanks and coils for each and every kind of vaper out there. The TFV8 Baby Series offers a wide range of ohm levels and wattages to satisfy any style of vaping.

These coils are NOT compatible and cannot be used with Smok Cloud Beast Tanks.

V8 Baby Q2 0.4Ω – Dual 40-80W (Best at 55-65W)

These coils offer deep and rich flavour and excellent vapour production. The V8 Baby Q2 coils do not come preinstalled with Smok tanks but are an optional extra to further enhance your vaping experience.

To use: It is VERY important to prime any new coils as this starts the wicking process and helps to prevent dry hits (can damage the coil and will taste awful). To prime simply unscrew the drip tip, top cap and glass tube (all in one piece) off the base to expose the enclosed coil. Unscrew the used coil and set aside. You may also want to disassemble your tank at this point as this is a good time to give the various components a good clean. Isopropyl Alcohol, cotton buds (Higher Standards Pipe Stix work well as the cotton does not unravel) and water should get your glass and top cap and drip tip back to almost new. Leave to air dry for around 10 minutes as electricity and water don’t mix well together!

Time to prime. Screw in your new coil – make sure it is no too tight as you will need to remove it again. Drip a small amount of your e juice onto the exposed cotton all around the perimeter of the coil. Screw the reassembled tank back onto your mod (510 threaded) and let stand for a few minutes for the cotton to saturate. To fill the tank hold with one hand and use the other hand to press the cap and then swivel the lid counter-clockwise. You can now add your e liquid via a dropper into the slot (be careful to not drip any into the centre airflow tube). Swivel back the top cap and allow the unit to sit for a few minutes (10-15). Now time for the primer puffs – without touching the firing button take a few sharp short pulls from the tank. You may see air bubbles rising to the top of the tank. You are now ready to vape!

TIP: GT Cores by Vaporesso are interchangeable with the TFV8 Baby range of coils.

Contains – 5 pack of Stainless Steel dual core V8 Baby – Q2 0.4Ω Coils

Colour

Red, Black

Brand