**No cartridge included with this battery.
Cartridge vaping has boomed in Australia in the past year. I have witnessed this firsthand in store whereby a year ago I sold almost no cartridges (empty, of course!) and only a small amount of battery sticks/mods specifically designed for cartridge vaping. For those of you who are unaware, cartridges are used for thick oil (usually herbal). These oils are dense and quite resinous and will not vape efficiently in standard vaporisers that are designed to vape e liquids.
Vapmod products are designed in California and are then manufactured in China (Sunzip Group). They pride themselves on providing a high level of quality with each of the products they create. Sunzip has a goal of bringing their customers a safe, efficient and gook looking device via intensive in-house research and development.
The V-mod is a petite little device, relatively flat and square. If discretion is your thing then you will love this mod as it can easily be held entirely within the palm of your hand. A cartridge (not included) will sit partly within the square with only a small section exposed (mouthpiece). Different lengths of cartridges will peek out at various heights – hole depth is 37mm.
TIP: As cartridges sit inside the mod it is important to ensure that the diameter of your cartridge isn’t too wide for insertion. Diameter = 11.5mm.
Cartridges are held in place via an included magnetic 510 connector that attaches to the base of each cartridge used. This magnet will keep the cartridge in place enabling easy removal/insertion when needed.
TIP: I would recommend keeping track of your used cartridges and checking before disposal, so you don’t accidentally throw out the magnetic connector!
The V-mod has quite an impressive battery capacity – 900mAh. This is a lot and according to Vapmod will last up to 600 puffs before a recharge will be required. I personally have not tested this assertion but find it to be believable as I currently use a much lower capacity battery (380mAh) and only charge once a week or so. The V-mod has a preheat function and will allow you to modify your voltage with 3 levels offered.
I love safety, especially whilst vaping. The V-mod comes complete with a myriad of safety features allowing you to vape without worrying. The following come standard:
- Overcharge protection
- Over-voltage protection
- Over-current protection
- Over discharge protection
- Short circuit protection
To use: Ensure your V-mod is charged. Attach the magnetic connector to the base of the cartridge being used. You can then easily insert your cartridge and it will be held in place. X5 clicks will turn your battery on (same for off). The light will flash twice when turned on and only once when turned off. Once your mod is on x3 clicks will allow you to cycle through the 3 pre-set voltages. See above table for corresponding colour light.
TIP: If your oil becomes thick/gluggy or has become cold you may want to utilise the preheat function. X2 clicks will begin the process (red light will “breathe”) and will continue for 15 seconds or until you click once to end it.
To Clean: Not much to clean with this battery/mod. The 2 area that I would focus on would be the base of the cartridge insertion point and the body of the unit itself. Power transfers from the battery to your cartridge via the base of the insertion hole and I would recommend you keep the area oil/grime free by occasionally inserting a dry cotton bud to mop anything up. Please ensure that no cotton fibres remain within. As for the body of the unit I would simply wipe down with a slightly damp cloth as needed.
Contains – x1 Vmod battery, x1 510magnet connector ring, x1 USB Cable and x1 User guide.
- Battery capacity: 900mAh
- Length: 49mm
- Width: 49mm
- Height: 14mm
- Weight: 85g
- Hole depth: 37mm
- Hole diameter: 11.5mm
- Output voltage: 2.6 – 4.1v
- Preheat output: 1.8v
- Preheat time: 15 seconds
- Puffs per charge: 600